Renesas R0E330850ACBP0 用户手册

 

 

 

 

z Be sure to connect this product to the user system, and supply power from the Vcc1 pin. 
z Use the power pin Vcc1 with 5.5 V or less. If the Vcc1 pin is set to 5.6 V or more accidentally, the LED1 and LED2 

will light up to notify it. If the LEDs light up, turn the power off immediately.   

z If the pins protected against overvoltage are overvoltaged, the voltage of the Vcc1 pin may rise up to 5.6 V because 

of reverse current. When you need to maintain the Vcc1 pin voltage of the user system, add dummy resistance and 
voltage regulator diode to the power line of the Vcc1. (Figure 3 is a mounting example.) 

z Do NOT touch this product while powering on. Part of the circuit may be at a high temperature immediately after 

turning off the emulator. Please take some time to let it cool down before touching this product. 

 

z It does not provide any guarantees to protect the emulator from any possible improper connection with the user 

system. For details, refer to the specifications. 

z When using this product, the electrical characteristics change slightly compared with when not using it. For final 

evaluation or characteristics verification, use the evaluation MCU. 

z We cannot accept any request for repair. When requesting for repair of the emulator used with this product, refer to 

“7. Troubleshooting” on page 6. 

z For inquiries about the product or the contents of this manual, contact your local distributor. 
 

Renesas Tools Homepage 

http://www.renesas.com/tools 

 

 

 
 

 
 
 
 

 

Figure 3 Example of component mounting (When restricting the voltage to 3.6 V or less in the 3.3 V user system) 

(4/8)