Motorola SBV5222 用户手册

Installation

Troubleshooting

Glossary

   

To install and configure your digital voice modem for a single PC running Microsoft Windows, we recommend 
using the Installation Assistant. You can start the Installation Assistant from the Main Menu on the SURFboard 
Voice Modem CD-ROM. In most cases, the Installation Assistant automatically configures your digital voice 
modem.

Otherwise, to install and configure your digital voice modem:

Connect the cables as described for your situation:

•

•

If you are using the 

 port only, go to 

 on page 12. Ethernet users can skip this 

Configure 

 and verify the 

 for your computer as described for your situation:

•

For Windows computers, see 

•

Refer to your Macintosh or UNIX user manual for information regarding TCP/IP and IP address 

configuration.

Allow some time (5 to 30 minutes) to power up the first time because the SURFboard Digital Voice Modem must 
find and lock on the appropriate channels for communications.

Be sure your computer is on and the digital voice modem is unplugged.

Connect one end of the coaxial cable to the cable outlet or splitter. Connect the other end of the coaxial cable 
to the CABLE connector on the digital voice modem. Hand-tighten the connectors to avoid damaging them. 

Insert the SURFboard Voice Modem CD-ROM into your CD-ROM drive.

Plug the AC power cord into the connector on the digital voice modem and an unswitched AC electrical outlet. 

This turns on the SURFboard Digital Voice Modem. You do not need to unplug it when not in use.

To cable outlet 
(step 2)

Always connect coaxial cable 
to the wall outlet first.

To electrical outlet (step 4)