Motorola MVME172 用户手册
Functional Blocks
http://www.mcg.mot.com/literature
2-19
2
The write post bus error interrupter is an edge-sensitive interrupter
connected to the local bus to VMEbus write post bus error signal line.
connected to the local bus to VMEbus write post bus error signal line.
The VMEbus IRQ1 edge-sensitive interrupter is an edge-sensitive
interrupter connected to the VMEbus IRQ1 signal line. This interrupter is
used when one of the tick timers is connected to the IRQ1 signal line.
When this interrupt is acknowledged, the vector is provided by the
VMEchip2 and a VMEbus interrupt acknowledge is not generated. When
this interrupt is enabled, the VMEbus IRQ1 level-sensitive interrupter
should be disabled.
interrupter connected to the VMEbus IRQ1 signal line. This interrupter is
used when one of the tick timers is connected to the IRQ1 signal line.
When this interrupt is acknowledged, the vector is provided by the
VMEchip2 and a VMEbus interrupt acknowledge is not generated. When
this interrupt is enabled, the VMEbus IRQ1 level-sensitive interrupter
should be disabled.
The VMEchip2 VMEbus interrupter acknowledge interrupter is an edge-
sensitive interrupter connected to the acknowledge output of the VMEbus
interrupter. An interrupt is generated when an interrupt on the VMEbus
from VMEchip2 is acknowledged by a VMEbus interrupt handler.
sensitive interrupter connected to the acknowledge output of the VMEbus
interrupter. An interrupt is generated when an interrupt on the VMEbus
from VMEchip2 is acknowledged by a VMEbus interrupt handler.
The tick timer interrupters are edge-sensitive interrupters connected to the
output of the tick timers.
output of the tick timers.
The DMAC interrupter is an edge-sensitive interrupter connected to the
DMAC.
DMAC.
The GCSR SIG3-0 interrupters are edge-sensitive interrupters connected
to the output of the signal bits in the GCSR.
to the output of the signal bits in the GCSR.
The location monitor interrupters are edge-sensitive interrupters connected
to the location monitor bits in the GCSR.
to the location monitor bits in the GCSR.
The software 7-0 interrupters can be set by software to generate interrupts.
The VMEbus IRQ7-1 interrupters are level-sensitive interrupters
connected to the VMEbus IRQ7-1 signal lines.
connected to the VMEbus IRQ7-1 signal lines.
The interrupt handler provides all logic necessary to identify and handle all
local interrupts as well as VMEbus interrupts. When a local interrupt is
acknowledged, a unique vector is provided by the chip. Edge-sensitive
interrupters are not cleared during the interrupt acknowledge cycle and
must by reset by software as required. If the interrupt source is the
VMEbus, the interrupt handler instructs the VMEbus master to execute a
VMEbus IACK cycle to obtain the vector from the VMEbus interrupter.
The chip connects to all signals that a VMEbus handler is required to drive
local interrupts as well as VMEbus interrupts. When a local interrupt is
acknowledged, a unique vector is provided by the chip. Edge-sensitive
interrupters are not cleared during the interrupt acknowledge cycle and
must by reset by software as required. If the interrupt source is the
VMEbus, the interrupt handler instructs the VMEbus master to execute a
VMEbus IACK cycle to obtain the vector from the VMEbus interrupter.
The chip connects to all signals that a VMEbus handler is required to drive