Acer AcceleRAID 352 用户手册
Installation
Manual No. 775051
2-11
Preparing the SCSI Drives
To prepare the drives for installation, follow these steps:
• Remove any terminators attached to the drive or set any drive
termination jumpers to the disabled position.
• Set the SCSI IDs on the drives.
• Enable term power on the drives.
Refer to the drive manual for specific information about drive configuration
settings.
settings.
Installing Cables and Setting Termination
Please refer to Table 2-5 for SCSI Formats and Bus Length requirements.
5. Connect the SCSI cables from the internal disk drives to the SCSI
connector(s) on the AcceleRAID 352 controller, as shown in
Figure 2-9. (The controller is already connected to the system board.)
Figure 2-9. (The controller is already connected to the system board.)
Figure 2-9. Connecting Disk Drives to the AcceleRAID 352