Magma EB2 用户手册

26                

 

 Make sure that all PCIe cards are fully seated in their connectors. 
When correctly seated in its connector, you will notice a firm resistance 
when you pull up gently on the card. To keep the cards in place, secure 
them in the enclosure with their retaining screws (supplied with the 
Magma expansion chassis). 

If your PCIe card is too short for 

the adjustable card slot guides, you 

can rotate the slot guard to make if 

fit.  Simply loosen the adjustment 
screw for the slot you are using 

and slide the guard to pivot hole, as shown, and 
remove it. Next, rotate the slot guard 180° and 
reinsert it. Finally, adjust the card slot guard to fit 

the card’s length.

 

 

The sheer number of PCIe cards and device drivers available 
makes it impossible for Magma to fully test and certify all available 
PCIe cards for use in the Magma expansion chassis. Our best 
advice to you in this regard is to insist on full PCI Express 
Specification compliance from your card and system vendors. 
Cards and systems should be at least compliant with PCIe revision 
1.0 or better. Compliance in your system motherboard, PCIe 
cards, and console firmware (or BIOS) is your best assurance that 
everything will install and operate smoothly.