Nortel Networks BCM50a 用户手册
250 Appendix G Command Interpreter
N0115791
IP commands
lists and describes the IP commands. Each of these commands must be
preceded by
ip
. For example, type
ip address
to display the host IP address.
disp <name>
Displays the Ethernet driver counters.
status
<ch_name>
Shows the LAN status.
version
Displays the Ethernet device type.
edit
load
<1:LAN>
Loads Ethernet (1:LAN) data from the System
Parameters Table.
mtu
<value>
Sets the Ethernet data Maximum Transmission
Unit.
accessblock
<0:disable 1:enable>
Blocks Internet access.
speed
<auto|10/half|10/
full|100/half|100/
full>
full|100/half|100/
full>
Sets the Ethernet data speed and duplex.
save
Saves Ethernet data to the System Parameters
Table.
dynamic
Port
Port
dump
Displays the relationship between physical port
and channel.
set
<port> <type>
Sets physical port to a specific channel.
spt
Displays channel setting stored in SPT.
Table 59 IP commands
Command
Description
address
[addr]
Displays the host IP address.
alias
<iface>
Sets an alias for the specified interface.
aliasdis
<0|1>
Disables or enables the alias for the specified
interface.
arp
Table 58 Ether Commands
Command
Description