Panasonic BL-PA100A 用户手册

10

Useful Information

Once you have connected the adaptors where you plan to use them, use the 
procedure below to test the speed of each terminal’s network connection to the 
master. Make sure that the terminal has already been registered to a master (see 
page 7).

Press and hold the terminal’s SETUP button for about 1 second.

•

The indicators on the terminal light one at a time in succession for a few 
seconds.

The indicators light for a few seconds. This indicates the network speed test 
result.

Refer to the chart below to determine the network speed.

If you are not satisfied with the speed test result, connect the terminal to a 
different wall outlet and repeat the test.

•

At least one indicator (“Good” network speed) must be lit in order to use the 
terminal.

•

If you are not satisfied with the speed test result and have tried connecting the 
terminal to different wall outlets, refer to the troubleshooting section (see 
page 13).

•

If the electrical conditions in your home changes after performing the speed 
test, network speed may also change.

Once you are satisfied with the terminal’s speed test result, you are ready to 
connect each adaptor to a network device (broadband router, hub, computer, 
network printer, network camera, etc.; see page 9).

No link

Good

Less than

10 Mbps

*1

*1 Approximate data transmission speed when transmitting data using the UDP protocol.

Better

10 Mbps to 

30 Mbps

Best

More than 

30 Mbps

BL-PA100A_OI.book  Page 10  Thursday, March 16, 2006  4:14 PM