EXP Computer S200 用户手册
106
Bridging
LLC2 Local Termination
Configuring Local Termination
Configuring for
Local Termination
Local Termination
Perform the following procedures to configure Local Termination on a Bridge node.
Before You Begin
Connect to the node using Control Terminal Port (CTP) access.
Obtain the following information:
• MAC Address of the device being spoofed.
• SAP value of the device being spoofed.
Configuring the
Bridge
Bridge
Follow these steps to configure bridge parameters to enable Local Termination on a
node.
node.
Step
Action
1
Configure the node.
2
Configure the ports.
3
Configure the route selection table.
4
Configure the LAN connection table.
5
Configure the Mnemonic Table and PVC Setup table.
6
Configure the bridge for Local Termination.
Go to ““Configuring the Bridge” section on page 106”, for details on
configuring the bridge table for Local Termination.
configuring the bridge table for Local Termination.
Step
Action
Result
1
Select
Configure -> Configure
Bridge
from the Main menu.
Note
Bridge must be configured for
source routing.
(*Bridge Type=SR).
source routing.
(*Bridge Type=SR).
The Configure Bridge Record
menu appears.
menu appears.