Radio Shack FC-241 用户手册
Configuring Additional File Transfer Functions
Configuring a Router as a Server
FC-242
Cisco IOS Configuration Fundamentals Configuration Guide, Release 12.1
In addition, you can configure the Cisco IOS software to forward extended BOOTP requests over
asynchronous interfaces. Refer to the “Configuring SLIP and PPP” chapter of the Dial Solutions
Configuration Guide for more information.
asynchronous interfaces. Refer to the “Configuring SLIP and PPP” chapter of the Dial Solutions
Configuration Guide for more information.
Configuring a Router as a TFTP Server
As a TFTP server host, the router responds to TFTP Read Request messages by sending a copy of the
system image contained in ROM or one of the system images contained in Flash memory to the
requesting host. The TFTP Read Request message must use one of the filenames that are specified in the
configuration.
system image contained in ROM or one of the system images contained in Flash memory to the
requesting host. The TFTP Read Request message must use one of the filenames that are specified in the
configuration.
Note
For the Cisco 7000 family, the filename used must represent a software image that is
present in Flash memory. If no image resides in Flash memory, the client router will boot
the server’s ROM image as a default.
present in Flash memory. If no image resides in Flash memory, the client router will boot
the server’s ROM image as a default.
Flash memory can be used as a TFTP file server for other routers on the network. This feature allows
you to boot a remote router with an image that resides in the Flash server memory.
you to boot a remote router with an image that resides in the Flash server memory.
With Cisco IOS Release 11.0, Cisco 7000 family allow you to specify one of the different Flash memory
devices (bootflash:, slot0:, slot1:, slavebootflash:, slaveslot0:, or slaveslot1:) as the TFTP server.
devices (bootflash:, slot0:, slot1:, slavebootflash:, slaveslot0:, or slaveslot1:) as the TFTP server.
In the description that follows, one Cisco 7000 router is referred to as the Flash server, and all other
routers are referred to as client routers. Example configurations for the Flash server and client routers
include commands as necessary.
routers are referred to as client routers. Example configurations for the Flash server and client routers
include commands as necessary.
To configure a router as a TFTP server, perform the tasks in the following sections:
•
•
•
Performing Prerequisite Tasks
The server and client router must be able to reach each other before the TFTP function can be
implemented. Verify this connection by pinging between the server and client router (in either direction)
with the ping command.
implemented. Verify this connection by pinging between the server and client router (in either direction)
with the ping command.
An example use of the ping command is as follows:
Router# ping 172.16.101.101
In this example, the Internet Protocol (IP) address of 172.16.101.101 belongs to the client router.
Connectivity is indicated by a series of exclamation points (!), while a series of periods (.) plus [timed
out] or [failed] indicates no connection. If the connection fails, reconfigure the interface, check the
physical connection between the Flash server and client router, and ping again.
Connectivity is indicated by a series of exclamation points (!), while a series of periods (.) plus [timed
out] or [failed] indicates no connection. If the connection fails, reconfigure the interface, check the
physical connection between the Flash server and client router, and ping again.
After you verify the connection, ensure that a TFTP-bootable image is present on the server. This is the
system software image the client router will boot. Note the name of this software image so you can verify
it after the first client boot.
system software image the client router will boot. Note the name of this software image so you can verify
it after the first client boot.