ATTO Technology 2390C/R/D 用户指南
23
ATTO Technology Inc. FibreBridge Installation and Operation Manual
4.0 Update firmware
The ATTO FibreBridge has several processors which control the flow of data. The firmware to control
these processors can be upgraded in the field using the
these processors can be upgraded in the field using the
PUT
command from an FTP connection, or
ZModem utility over an RS-232 serial connection. The preferred method is to use ATTO ExpressNAV.
Note
The recommended management tool for
updating firmware for the FibreBridge is the
ATTO ExpressNAV interface. Use the Update
Firmware page.
updating firmware for the FibreBridge is the
ATTO ExpressNAV interface. Use the Update
Firmware page.
The FibreBridge firmware is distributed as an
.ima file and can be obtained from the ATTO web
site.
.ima file and can be obtained from the ATTO web
site.
Preliminary step
The FibreBridge firmware is distributed as an
.ima file from the ATTO Technology web site at
The FibreBridge firmware is distributed as an
.ima file from the ATTO Technology web site at
or from the CD included with
your bridge. Download the file and note the
filename.
filename.
CAUTION
CAUTION
Before beginning this procedure, ensure
that all I/O to the FibreBridge has stopped.
Before beginning this procedure, ensure
that all I/O to the FibreBridge has stopped.
During this procedure, do not interrupt the
flash process.
flash process.
Do not power down the host or the
FibreBridge until the display returns the
Ready prompt.
FibreBridge until the display returns the
Ready prompt.
Interrupting the flash process will make
your FibreBridge inoperable and you will
have to return it to ATTO Technology for
repair.
your FibreBridge inoperable and you will
have to return it to ATTO Technology for
repair.
Using ExpressNAV
1
If you are not already in the ExpressNAV
interface, type the IP address of your
FibreBridge in a standard browser as found in
interface, type the IP address of your
FibreBridge in a standard browser as found in
Enter
Here, type in your user name and password,
and click
and click
OK.
2
Click on the
Firmware menu item for the left-
hand side of the page.
3
The
Firmware Update page appears. Click
Browse to locate the firmware you downloaded
in the preliminary step.
in the preliminary step.
4
Highlight the file.
5
Click
Upload.
6
Wait until a success message is displayed.
7
Click on the
Restart menu item on the left-hand
side of the page.
8
The
Restart page appears. Click on Restart.
Using FTP
1
Establish an FTP link to the bridge that is to be
flashed.
flashed.
2
Use the
PUT command to download the
firmware file to the bridge. For example
PUT c:\bridge_firmware\FB3200100.IMA
3
Once the download is complete, cycle power on
the FibreBridge to implement the new firmware.
the FibreBridge to implement the new firmware.
Using the zModem command
1
Load a Terminal Program such as Hyper
Terminal.
Terminal.
2
Set the terminal and the FibreBridge for the
highest possible baud rate for your terminal.
highest possible baud rate for your terminal.
3
Turn on power to the FibreBridge.
4
Once the
Ready prompt appears, type
ZMODEM RECEIVE. The FibreBridge displays
that it is preparing to receive a file from your
terminal program.
that it is preparing to receive a file from your
terminal program.
5
On the terminal program, choose
Transfer
Send File