ZyXEL Communications NBG-418N v2 用户手册
Chapter 6 Wireless LAN
NBG-418N v2 User’s Guide
70
6.7 WPS Screen
Use this screen to enable/disable WPS, view or generate a new PIN number and check current WPS
status. To open this screen, click Network > Wireless LAN > WPS tab.
status. To open this screen, click Network > Wireless LAN > WPS tab.
Figure 48
Network > Wireless LAN > WPS
The following table describes the labels in this screen.
Enable Intra-BSS
Traffic
Traffic
A Basic Service Set (BSS) exists when all communications between wireless clients or
between a wireless client and a wired network client go through one access point (AP).
between a wireless client and a wired network client go through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is
enabled, wireless client A and B can access the wired network and communicate with
each other. When Intra-BSS is disabled, wireless client A and B can still access the wired
network but cannot communicate with each other.
enabled, wireless client A and B can access the wired network and communicate with
each other. When Intra-BSS is disabled, wireless client A and B can still access the wired
network but cannot communicate with each other.
Apply
Click Apply to save your changes to the NBG-418N v2.
Reset
Click Reset to reload the previous configuration for this screen.
Table 22
Network > Wireless LAN > Advanced (Universal Repeater Mode)
LABEL
DESCRIPTION
Table 23
Network > Wireless LAN > WPS
LABEL
DESCRIPTION
WPS Setup
Enable WPS
Click the Enable WPS check box to enable the WPS feature. Click again to disable it.
PIN Number
This displays a PIN number last time system generated. Click Generate to generate a
new PIN number.
new PIN number.
WPS Status
Status
This displays Configured when the NBG-418N v2 has connected to a wireless network
using WPS or when Enable WPS is selected and wireless or wireless security settings
have been changed. The current wireless and wireless security settings also appear in the
screen.
using WPS or when Enable WPS is selected and wireless or wireless security settings
have been changed. The current wireless and wireless security settings also appear in the
screen.
This displays Unconfigured if WPS is disabled and there are no wireless or wireless
security changes on the NBG-418N v2 or you click Release_Configuration to remove
the configured wireless and wireless security settings.
security changes on the NBG-418N v2 or you click Release_Configuration to remove
the configured wireless and wireless security settings.
Release
Configuration
Configuration
This button is only available when the WPS status displays Configured.
Click this button to remove all configured wireless and wireless security settings for WPS
connections on the NBG-418N v2.
connections on the NBG-418N v2.