ZyXEL Communications VSG-1200 V2 用户手册
VSG-1200 V2 User’s Guide
41
Chapter 2 Hardware Installation and Connection
2.2.2 Front Panel LEDs
The following table describes the LEDs on the front panel. When turned on, all LEDs are
green unless otherwise specified.
green unless otherwise specified.
2.2.3 Rear Panel
The power socket, the fan and a ventilation hole are located on the rear panel as shown next.
Note: Do NOT block the ventilation hole.
Figure 7 Rear Panel
2.2.4 Turning on the VSG
Connect the female end of the supplied power cord to the power socket on the back of the
VSG and the male end to an appropriate power source.
VSG and the male end to an appropriate power source.
When the power source is turned on, the PWR LED on the front panel turns on.
Table 1 Front Panel LEDs
LED
STATUS
DESCRIPTION
PWR
On
The VSG is receiving power.
Off
The VSG is not receiving power.
SYS
On
The system is functioning normally.
Blinking
The system is not functioning properly.
Off
The system is not ready or has failed.
LAN or WAN
10
On
The port is connected at 10 Mbps.
Blinking
The port is receiving or sending data.
Off
The port is not connected to an Ethernet device.
100
On
The port is connected at 100 Mbps.
Blinking
The port is receiving or sending data.
Off
The port is not connected to an Ethernet device.