Alcatel Carrier Internetworking Solutions Switch/Router 用户手册

Page 12-21

The 

 command is used to display information about the local switch’s implementation 

of 

NTP

. To view local switch 

NTP

 information, enter the 

 command at the system 

prompt. A screen similar to the following is shown:

The following section explains the fields shown using the 

 command.

 The 

IP

 address of the switch.

. The peer mode of this remote association. There are five possible modes: 

symmetric active, symmetric passive, client, server, and broadcast. The displayed mode is 
assumed if this association becomes the switch’s host 

NTP

 server. For a description of the 

modes, see Display List of Peers the Server Knows About on page 12-15. For a description of 
how to configure a peer, see Configuring a New Peer Association on page 12-12.

. The status of leap second insertion for this association. Leap seconds are 

seconds that are added to the timestamp of an 

NTP

 entity to correct accumulated time errors. 

The possible values are:

No warning.

Last minute has 61 seconds.

Last minute has 59 seconds.

Alarm condition (clock not synchronized)

. The stratum level of the remote peer. If this number is 

, the remote peer has not 

been synchronized.

. The advertised precision of the switch. It will be a number between -4 and -20.

. This is a signed fixed-point number indicating the total roundtrip delay to the 

primary reference source at the root of the synchronization subnet, in seconds. Note that this 
variable can take on both positive and negative values, depending on clock precision and 
skew.

. This is a signed fixed-point number indicating the maximum error relative to 

the primary reference source at the root of the synchronization subnet, in seconds. Only posi-
tive values are possible.

. This is a 32-bit code identifying the particular reference clock. In the case of 

stratum 0 (unspecified) or stratum 1 (primary reference source), this is a four-octet, left-justi-
fied, zero-padded 

ASCII

 string. In the case of stratum 2 and greater (secondary reference) this 

is the four-octet Internet address of the peer selected for synchronization.