Alcatel Carrier Internetworking Solutions Switch/Router 用户手册
The Switch Menu
Page 18-26
Default Ethernet Translations
The
ethdef
allows you to set up default translations for all Ethernet ports. To do so:
1. Enter
ethdef
at the system prompt. The following screen displays:
This will reset the default translations for Ethernet media to a new value.
All Ethernet ports currently set to default will inherit these new translation options.
It will thenreset the forwarding table translation options for all addresses learnt on
those ports to those port defaults.
Do you want to do this? (no):
All Ethernet ports currently set to default will inherit these new translation options.
It will thenreset the forwarding table translation options for all addresses learnt on
those ports to those port defaults.
Do you want to do this? (no):
2. Press
Y
at the
Do you wish to do this?
prompt to indicate that you want to change the
defaults. The current settings for Ethernet ports are displayed, in a screen similar to the
following:
following:
Translation Options:
1
1
IP Ethertype
-> Ethertype
2
IP IEEE 802 SNAP
-> Ethertype
3
IPX ETHERNET_II
-> 802.3
4
IPX ETHERNET_802.3
-> 802.3
5
IPX ETHERNET_802.3/FDDI/TOKEN_RING
-> 802.3
6
IPX ETHERNET_SNAP/FDDI_SNAP/TOKEN-RING_SNAP
-> 802.3
There are six frame types for which you can set translation options. The frame type in the
left column indicates the incoming frame, and the frame type in the right column (after
the
left column indicates the incoming frame, and the frame type in the right column (after
the
->
) indicates the outgoing frame. You can configure the outgoing frame type for each
incoming frame.
3. You change an outgoing frame type by entering its line number, an equal sign (=) and a
frame type indicator (
e
,
s
,
2
, or
3
). The frame type indicators represent the following
frames:
e
Ethernet II or Ethertype
s
SNAP
2
802.2 or LLC
3
Ethernet
802.3
For example, if you wanted to change incoming IPX Ethernet II frames to Ethernet 802.3
frames, then you would enter
frames, then you would enter
3=3
Please note that the IP Translation Options accept only Ethertype (
e
) or SNAP (
s
).
4. When you are done changing translations, enter
save
to save all of your settings. If you
enter
quit
, you will exit the
ethdef
command without saving your changes.