Alcatel Carrier Internetworking Solutions Switch/Router 用户手册

Page 1-27

The OmniS/R-9P can use a DC power supply called the OmniS/R-PS9-DC725. This power 
supply contains a female power connector as shown in the figure below. This supply requires 
the use of 10 gauge wire. A clamp inside each connector keeps the power wire tightly in 
place during operation.

Caution: To reduce the risk of electric shock or energy hazards: 

• The branch circuit overcurrent protection must be rated at a minimum of 30 A (amperes) 

for the OmniS/R-9P PS9-DC725.

• Use 10 gauge (AWG - American Wire Gauge) solid copper conductors only for the 

OmniS/R-9P PS9-DC725.

• A readily-accessible disconnect device that is suitably approved and rated shall be incorpo-

rated in the field wiring.

• This device is to be installed in a restricted access area in accordance with the NEC 

(National Electrical Code) or the authority having jurisdiction.

• Connect this device to a reliably grounded SELV (Safety Extra Low Voltage) or a central-

ized DC source.