Alcatel Carrier Internetworking Solutions Switch/Router 用户手册
Modifying a Group or VLAN
Page 19-42
Enabling IP or IPX Routing
If you enable
IP
or
IPX
routing by setting the corresponding
modvl
lines from
N
to
Y
, then the
screen automatically refreshes with additional lines for the new router port parameters. All
lines are set to router defaults. The router defaults are as follows:
lines are set to router defaults. The router defaults are as follows:
IP Router
IP Network Address
0.0.0.0
IP Subnet Mask
0.0.0.0
IP Broadcast Address
0.0.0.0
Router Description
(no description shown for default)
Routing Disabled
No
RIP Mode
Silent
Default Framing Type
Ethernet II
IPX Router
IPX Network Address
0x0
Router Description
(no description shown for default)
Delay in Ticks
0
RIP/SAP Mode
RIP and SAP are active
Default Framing Type
Ethernet II
You can change any of these defaults as you would any other
modvl
parameters: enter the
line number, followed by an equal sign (=) and the new parameter.
♦ Note ♦
You must at least enter a Network Address for a new
router or you will not be able to save the configuration.
router or you will not be able to save the configuration.