Alcatel Carrier Internetworking Solutions Switch/Router 用户手册

Page 29-51

To obtain status information on a single virtual circuit, you enter the 

 command along 

with the slot number for the 

WSX

 board, the port number, and 

DLCI

 number for the virtual 

circuit on which you want information, as follows:

where 

 is the slot number where the 

WSX

 board is installed, 

 is the port number 

on the 

WSX

 board, and 

 is the 

virtual circuit identifi

er. For example, if you wanted to 

obtain status information for the board in slot 4, port 1, 

DLCI

 32, you would enter:

This command displays a screen similar to the following:

The top of the display provides information on the status of this virtual circuit. The 

 field indicates the current Administrative and Operation Status for this virtual 

circuit. The next informational field, 

, indi-

cates the current Administrative and Operational status for Compression Negotiation on this 
VC. The Administrative Status will be either 

 or 

. The Operational Phase will 

be 

 (compression negotiation not enabled), 

 (compression negotiation in 

progress), or 

 (negotiation successful, data being compressed).

The table below the status information breaks down traffic on the virtual circuit by protocol 
type. Each row corresponds to a frame type, such as Ethernet or 

IPX

. For each frame type, the 

number of frames received, frames transmitted, octets received, and octets transmitted is 
given. The final two columns of the table (

 and 

) represent the total percentage of 

traffic (octets, not frames) for that protocol type.