Sanyo PLC-XD2600 用户手册

This projector uses nominal input voltages of 100-240 V AC

and  it  automatically  selects  the  correct  input  voltage.  It  is

designed to work with single-phase power systems having a

grounded  neutral  conductor. To  reduce  the  risk  of  electrical

shock, do not plug into any other type of power system.

If  you  are  not  sure  of  the  type  of  power  being  supplied,

consult your authorized dealer or service center.

Connect  the  projector  with  all  peripheral  equipment  before

turning the projector on.

✔

Note:

Unplug the AC power cord when the projector is not

in use. When this projector is connected to an outlet

with the AC power cord, it is in Stand-by mode and

consumes a little electric power.

To the AC outlet.

AC power cord must meet requirement of the country where you use the projector.

Confirm the AC plug type with the chart below and proper AC power cord must be used.

If supplied AC power cord does not match your AC outlet, contact your sales dealer.

To power cord

connector on your

projector.

To the AC outlet.

To the AC outlet.

 

The AC outlet must be near this equipment and must be

easily accessible.

Connect  the AC  power  cord  (supplied)  to  the

projector.

Ground

Ground

➞

➞