Fisher PDG-DWT50L 用户手册
2. Installation and Connections
31
Connecting the Supplied Power Cable
This projector uses nominal input voltages of 100–120V or 200–240V AC and it automatically selects the correct input volt-
age. It is designed to work with single-phase power systems having a grounded neutral conductor. To reduce the risk of
electrical shock, do not plug into any other type of power system. If you are not sure of the type of power being supplied,
consult your authorized dealer or service station. Connect the projector with all peripheral equipment before turning the
projector on.
age. It is designed to work with single-phase power systems having a grounded neutral conductor. To reduce the risk of
electrical shock, do not plug into any other type of power system. If you are not sure of the type of power being supplied,
consult your authorized dealer or service station. Connect the projector with all peripheral equipment before turning the
projector on.
CAUTION
For safety, unplug the AC power cord when the projector is not in use. When the projector is con-
nected to an outlet with the AC power cord, it is in stand-by mode and consumes a small amount of
electrical power.
nected to an outlet with the AC power cord, it is in stand-by mode and consumes a small amount of
electrical power.
NOTE ON THE POWER CORD
The AC power cord must meet the requirements of the country where you are utilizing the projector. Confirm the AC plug
type with the chart below. The proper AC power cord must be used. If the supplied AC power cord does not match your AC
outlet, contact your sales dealer.
type with the chart below. The proper AC power cord must be used. If the supplied AC power cord does not match your AC
outlet, contact your sales dealer.
Note:
Make sure that the prongs are fully inserted into both the AC IN and the wall outlet.
Make sure that the prongs are fully inserted into both the AC IN and the wall outlet.
CAUTION
Ensure that the cables do not create a trip hazard.