Fisher PDG-DWT50L 用户手册
32
3. Projecting an Image (Basic Operation)
Turning on the Projector
Once the projector is correctly located and the power cable and other connections are in place, it is important that the pro-
jector is powered on correctly in order to avoid damage to components and unnecessary wear and tear. Refer to the
following guide to power on the projector.
jector is powered on correctly in order to avoid damage to components and unnecessary wear and tear. Refer to the
following guide to power on the projector.
1.
Connect the power cable (A). Press the
main power switch to the on ( I ) posi-
tion as shown (B). The power LED
lights orange and warning LED lights
green.
main power switch to the on ( I ) posi-
tion as shown (B). The power LED
lights orange and warning LED lights
green.
B
A
2.
Press the On/Standby button once (see
OSD Controls and Status LEDS on
page
OSD Controls and Status LEDS on
page
and the internal cooling fan starts.
3.
After approximately 10 seconds, the
power LED flashes intermittently green.
power LED flashes intermittently green.
4.
The Lamp1 and Lamp2 LEDs light
green and the Power LED flashes more
rapidly.
green and the Power LED flashes more
rapidly.
5.
Once the power LED is lit a solid green,
the projector is ready for use.
the projector is ready for use.
Note:
If any of the LEDs remain flashing or blink there may be a problem with the startup. Please refer to the
If any of the LEDs remain flashing or blink there may be a problem with the startup. Please refer to the