Toshiba 3511 用户手册

November 2003  ©  TOSHIBA TEC

3 - 87

e-STUDIO3511/4511 ADJUSTMENT

(3)

Turn ON the power.

(4)

Press SW602 on the punch controller PC board. Sensor output is adjusted automatically when

the switch is pressed.

• Adjustment is complete if LED601 and LED602 on the punch controller PC board blinks

alternately.

(5)

Press SW602 or SW603 on the punch controller PC board to end the adjustment mode and set

all bits of SW601 to OFF.

(6)

Turn OFF the power.

ON

1

2

3

4

Perform this adjustment when replacing the punch controller PC board, transmittance sensor (photosensor

PC board/LED PC board), or deflection sensor (scrap full detector PC board unit).

(1)

Check that the power is OFF and then remove the rear cover of the puncher.

(2)

Set SW601 on the punch controller PC board as shown below.

The binding position/folding position can be adjusted in the following (05) codes.

Code

Paper size

468-0

A4-R / LT-R

468-1

B4

468-2

A3 / LD

Remarks

When the value increases, the binding/folding position shifts toward

the right page. (0.25mm/step)

Acceptable values: -14 to 14 (Default: 0)

Increase the adjustment value when the sheet of paper which has exited is "A".

Decrease the adjustment value when the sheet of paper which has exited is "B".

A: When the upper side of the folding

is longer than the lower side

B: When the upper side of the folding is

shorter than the lower side

← Paper feeding direction

← Paper feeding direction