Toshiba 3511 用户手册

e-STUDIO3511/4511 ADJUSTMENT

3 - 88

November 2003  ©  TOSHIBA TEC

Number of punch holes

LED601/LED602

2 hole (E)

Blinks 1 times per cycle

2/3 hole (N)

Blinks 2 times per cycle

4 hole (F)

Blinks 3 times per cycle

4 hole (S)

Blinks 4 times per cycle

(3)

Turn ON the power.

(4)

Press SW602 on the punch controller PC board to select the number of punch holes.

• The items in the following table are displayed repeatedly from top to bottom each time SW602

is pressed.

This operation registers which puncher unit is attached to the IC on the punch driver PC board so that

the puncher unit can be identified by the finisher. For this reason, this operation must be performed

when the punch driver PC board has been replaced.

(1)

Check that the power is OFF and then remove the rear cover of the puncher.

(2)

Set SW601 on the punch controller PC board as shown below.

ON

1

2

3

4

(5)

Press SW603 on the punch controller PC board. The number of punch holes is registered to the

punch controller PC board each time the switch is pressed.

• Registration is complete if LED601 and LED602 on the punch controller PC board blinks

alternately.

(6)

Press SW602 or SW603 on the punch controller PC board to end the adjustment mode and set

all bits of SW601 to OFF.

(7)

Turn OFF the power.