Xerox 12.7 B 114 用户手册
6.3 6050/6030 Specific
6.3.1 Configuring the Remote printer
The address of the remote printer should not be changed while there is an active print job in the
printer queue. If you attempt to change the address of the remote printer in this situation you will
need to restart the controller in order to complete the address change.
printer queue. If you attempt to change the address of the remote printer in this situation you will
need to restart the controller in order to complete the address change.
6.4 Controller
6.4.1 Stamp does not appear
If the user tries to upload a stamp files that contains an invalid format, or if the Accounting Mode is
set to “Enabled”, no error message will be displayed. The WebPMT screen will display a message
that the file was uploaded successfully and the stamp’s filename will not appear in the “Printer
Resident Stamps” list. To avoid this situation, set the Job Accounting mode to “Optional” before
uploading stamps. The WebPMT has no knowledge of the validity of any file that is sent to the
printer. File validation and error handling is done on the printer by the FreeFlow Accxes controller.
The WebPMT only reports that the file was sent to the printer successfully.
set to “Enabled”, no error message will be displayed. The WebPMT screen will display a message
that the file was uploaded successfully and the stamp’s filename will not appear in the “Printer
Resident Stamps” list. To avoid this situation, set the Job Accounting mode to “Optional” before
uploading stamps. The WebPMT has no knowledge of the validity of any file that is sent to the
printer. File validation and error handling is done on the printer by the FreeFlow Accxes controller.
The WebPMT only reports that the file was sent to the printer successfully.
6.4.2 Scaling interaction with “ANY”
The media size “ANY” will select the best sheet size for an image to prevent clipping. If a user
specifies a media size of “ANY” and a scale factor that makes the image too large for any sheet
size and mismatch mode is set to scale, the controller will select the largest sheet size and scale
the image to fit on it.
specifies a media size of “ANY” and a scale factor that makes the image too large for any sheet
size and mismatch mode is set to scale, the controller will select the largest sheet size and scale
the image to fit on it.
If this is not the desired behavior, a specific sheet size can be selected, or the media mismatch
mode can be set to QUERY.
mode can be set to QUERY.
6.4.3 Margins may cause image clipping
If the margins (TOP, BOTTOM, RIGHT and LEFT) are set to a non-zero value (5mm is the
default) then that amount of whitespace will be added to the image before placing it on the media
and could cause part of the image to be shifted off the page, or clipped. To correct this problem
set the margins to 0.
default) then that amount of whitespace will be added to the image before placing it on the media
and could cause part of the image to be shifted off the page, or clipped. To correct this problem
set the margins to 0.
6.4.4 CGM Files and folding
Certain CGM files contain rotation commands which can confuse the system when folding. If the
titleblock is not visible or the plot is bypassed and not folded, change the titleblock location to
obtain a correctly folded document.
titleblock is not visible or the plot is bypassed and not folded, change the titleblock location to
obtain a correctly folded document.
6.5 Wide Format Scanner
Page 11