Yamaha VL70-m 用户手册
41
DevNo. (Device Number)
Settings: 001 … 016, all
The Device Number parameter must be set prop-
erly when you want to transmit or receive MIDI
system exclusive data to or from another VL70-m
or other MIDI device (system exclusive data
includes voice parameters, system setup param-
eters, etc). The VL70-m Device number must be
set to the same number as the Device Number of
the external device. Select a device number from
“001” to “016”, or “all” . When “all” is selected,
MIDI system exclusive data can be received on all
device numbers, but transmission occurs via device
number 001.
erly when you want to transmit or receive MIDI
system exclusive data to or from another VL70-m
or other MIDI device (system exclusive data
includes voice parameters, system setup param-
eters, etc). The VL70-m Device number must be
set to the same number as the Device Number of
the external device. Select a device number from
“001” to “016”, or “all” . When “all” is selected,
MIDI system exclusive data can be received on all
device numbers, but transmission occurs via device
number 001.
M.Volum (Master Volume)
Settings: 000 … 127
Sets the VL70-m master volume level. The higher
the value the louder the volume.
the value the louder the volume.
RevRtn (Reverb Return)
Settings: 000 … 127
Adjusts the level of the signal returned from the
VL70-m reverb effect stage. The higher the value,
the higher the level of the reverb signal.
VL70-m reverb effect stage. The higher the value,
the higher the level of the reverb signal.
ChoRtn (Chorus Return)
Settings: 000 … 127
Adjusts the level of the signal returned from the
VL70-m chorus effect stage. The higher the value,
the higher the level of the chorus signal.
VL70-m chorus effect stage. The higher the value,
the higher the level of the chorus signal.
VarRtn (Variation Return)
Settings: 000 … 127
Adjusts the level of the signal returned from the
VL70-m variation effect stage. The higher the
value, the higher the level of the variation signal.
This parameter is not available (“***” will appear
in place of the VarRtn value) when the variation
stage is connected as an “insertion” effect (page
86).
VL70-m variation effect stage. The higher the
value, the higher the level of the variation signal.
This parameter is not available (“***” will appear
in place of the VarRtn value) when the variation
stage is connected as an “insertion” effect (page
86).
Trans (Transpose)
Settings: -24 … 0 … +24
Transposes the pitch of the entire VL70-m system
(a single setting applies to all voices) down or up
in semitone steps over a
(a single setting applies to all voices) down or up
in semitone steps over a
±
2 octave range. “+00”
corresponds to standard pitch. Each increment
corresponds to a semitone. A setting of “-12”, for
example, transposes the pitch down one octave.
corresponds to a semitone. A setting of “-12”, for
example, transposes the pitch down one octave.
The VL-XG PLAY Mode