SATO D512 用户手册

SATO D508/D512 Operator Manual

 

 Page 2-7

The SATO D508 / D512 printer can print to direct thermal die-cut labels, tags or continuous media. 
The media supply can be either in Roll or Fanfold format.

Roll Media
Roll media should be between 0.98" (25 mm) and 4.3" (110 mm) in width and wound face-out on a 
core with a minimum internal diameter of 1.6" (40 mm).

1.    Make sure the printer is turned OFF. 
 

2. Open the Top Cover by pressing on cover 

release points located on the right-hand side 
of the printer. This releases the Top Cover and 
allows it to swing upward on the rear mounted 
hinge points.

3.   With the Top Cover in the upright position, 

press the Paper Guide Release while adjust-
ing the Paper Guides until they allow a media 
roll to fit between them. A millimeter scale is 
molded into the case to provide a guide when 
making the adjustment. The Paper Guides are 
center justified and interact with each other so 
that each moves an equal distance.

4.   Make sure the Roll Holders are in the released 

position. If they are not, lift up on each one and 
they will snap to the open position. 

 

 

 

 

 

 

5.   Unwind approximately 12" of label material 

from the roll. The labels should be wound 
face-out (printing side to the outside of the 
roll). Drop the roll in-between the Paper 
Guides so that the labels come off the top of 
the roll. The Paper Guides will automatically 
position the Roll Holders to suspend the roll.