SATO D512 用户手册

Page 2-8

SATO D508/D512 Operator Manual

6.   Route the label material through the Paper 

Sensor Assembly and over the Platen. Note 
that the Sensor is part of the left Label Roll 
Guide so that the Paper Sensor is always 
positioned in the same location relative to 
the left edge of the label.

7.   Close the Top Cover.

8.   Press the LINE button so that the printer is 

in the OFF LINE mode and then press the 
FEED button. The label should advance to 
the next index (label gap) position.

Fanfold media

1.   Place the fanfold media behind the printer 

with the printing surface up. 

2.   Open the Top Cover by pressing on the cover 

release latch located on the right-hand side 
of the printer. This releases the cover and 
allows it to swing upward on the rear 
mounted hinge points.

3.   Carefully pull up the Fanfold-label Loading 

Slot from the back of the Top Cover.

4.   With the Top Cover in the upright position, 

press the Paper Guide Release while adjust-
ing the Paper Guides until they allow a media 
to fit between them. A millimeter scale is 
molded into the case to provide a guide when 
making the adjustment. The Paper Guides 
are center-justified and interact with each 
other so that each moves an equal distance 
apart from each other.

5.   Route the label material through the Sensor 

Assembly and over the Platen.