Zebra Technologies P1043301-005 用户手册

Troubleshooting the Wireless Print Server

11/21/13

P1043301-005 

You may need to set your country code in order to enable the 5Ghz band for the Zebranet n 

Print Server. 

• If you are using the wireless print server in the United States, Canada, or Japan, you will 

not need to set the country code. These countries have been pre-set at the factory. 

• If you are operating the print server anywhere else in the world, you must set the country 

code to enable the 5GHz band. To set the country code, you must send a Set-Get-Do 
command to the printer. For specific command information, see the Programming Guide 
for ZPL II, ZBI 2, Set-Get-Do, Mirror and WML.

You may need to restore the network parameters to the factory defaults under the following 

circumstances:

• If you download a different version of firmware to your printer

• If you need to reset the encryption keys (for instances where a key was entered incorrectly 

or was forgotten)

After you return the network parameters to the defaults, you must reconfigure your printer to 

). If you 

saved the ZPL script generated by the Wireless Setup Wizard, simply send this file to the 
printer, and then power cycle the printer. If you were using a wireless password, you must set it 
again (use the ^WP ZPL command or the wlan.password SGD command).

You can set the network parameters back to the factory defaults in two ways:

• The Restore Default Network Configuration button on the printer’s View and Modify 

• The 

 option, which appears as an option when you exit Setup mode. 

Refer to the User Guide for your printer for specific instructions on how to modify the 
control panel parameters.

Note • The 

 option and the Restore Default Configuration button 

reset all printer parameters other than network settings back to factory defaults. The network 
settings will not change when these options are selected.