Zebra Technologies P1043301-005 用户手册
Hardware Troubleshooting
IP Issues
IP Issues
146
P1043301-005
11/21/13
IP Issues
Table 26 • IP Issues and Recommended Solutions
Issue
Possible Cause
Recommended Solution
The printer shows
IP
IP
address
192.168.254.254, which
does not appear to
work.
192.168.254.254, which
does not appear to
work.
IP address 192.168.254.254 is a
default address. The printer shows
this address after it times out while
trying to connect. The printer was
likely set to an incorrect static IP
address.
default address. The printer shows
this address after it times out while
trying to connect. The printer was
likely set to an incorrect static IP
address.
Enter a valid static IP address.
OR
Set IP Protocol to All.
OR
Set IP Protocol to All.
The DHCP server is not
functioning, so a dynamic IP
address is not being assigned. The
printer timed out and shows the
default IP address of
192.168.254.254.
functioning, so a dynamic IP
address is not being assigned. The
printer timed out and shows the
default IP address of
192.168.254.254.
Check the DHCP server.
On my control panel,
the IP settings are
missing or show all
zeroes
(000.000.000.000).
the IP settings are
missing or show all
zeroes
(000.000.000.000).
Actual IP settings (IP Resolution,
IP Address, Subnet Mask, and
Default Gateway) will only appear
when the printer is associated to
and authenticated with the WLAN.
Until the time that the printer
recognizes the existence of a
ZebraNet print server, these
parameters will not show through
the control panel. After the print
server is recognized, all zeroes will
display until the printer obtains an
IP address or defaults to address
192.168.254.254.
Default Gateway) will only appear
when the printer is associated to
and authenticated with the WLAN.
Until the time that the printer
recognizes the existence of a
ZebraNet print server, these
parameters will not show through
the control panel. After the print
server is recognized, all zeroes will
display until the printer obtains an
IP address or defaults to address
192.168.254.254.
1.
Allow more time for the printer to
complete its connection and obtain an
IP
IP
address.
2.
If the printer does not connect, check
that there is an adequate signal between
the printer and the access point. If
necessary, move the printer or the access
point to another location, or remove any
obstructions between the two. A direct
line of site between the printer and
access point provides the best results.
Refer to the third-party documentation
for your access point for
recommendations and limitations.
that there is an adequate signal between
the printer and the access point. If
necessary, move the printer or the access
point to another location, or remove any
obstructions between the two. A direct
line of site between the printer and
access point provides the best results.
Refer to the third-party documentation
for your access point for
recommendations and limitations.
3.
Check the IP Protocol setting. If using a
static setting, the value entered might
not be valid.
static setting, the value entered might
not be valid.
The IP address for my
wired print server does
not bring up the
printer home page.
wired print server does
not bring up the
printer home page.
If both a wired and wireless print
server are installed on a printer at
the same time and the wireless
printer is the primary/active print
server, the printer web pages can
be accessed only through the
wireless print server’s IP
server are installed on a printer at
the same time and the wireless
printer is the primary/active print
server, the printer web pages can
be accessed only through the
wireless print server’s IP
address.
In your browser window, type in the IP
address of the wireless print server.
address of the wireless print server.