Zebra Technologies Z4Mplus 用户手册
Configuration
Configuration and Calibration Sequence
Z4Mplus and Z6Mplus User Guide
61
Configuration and Calibration Sequence
Display Shows
Action/Explanation
PRINTER READY
Normal printer operation.
Set Print Parameters
DARKNESS Press
SELECT to make change.
Adjusting Print Darkness: Press PLUS (+) to increase
darkness.
Press MINUS (–) to decrease darkness.
darkness.
Press MINUS (–) to decrease darkness.
Default: +10
Range: 0 to +30
Press SELECT to accept the change.
Darkness settings are dependent upon a variety of factors,
including ribbon type, media, and the condition of the
printhead. You may adjust the darkness for consistent
high-quality printing.
including ribbon type, media, and the condition of the
printhead. You may adjust the darkness for consistent
high-quality printing.
If printing is too light, or if there are voids in printed areas,
increase the darkness. If printing is too dark, or if there is
spreading or bleeding of printed areas, decrease the
darkness.
increase the darkness. If printing is too dark, or if there is
spreading or bleeding of printed areas, decrease the
darkness.
Feed Self Test on
best darkness setting. Since the darkness setting takes effect
immediately, you can see the results on labels that are
currently printing.
immediately, you can see the results on labels that are
currently printing.
Set the darkness to the lowest setting that provides good
print quality. Darkness set too high may cause ink smearing
or it may burn through the ribbon.
print quality. Darkness set too high may cause ink smearing
or it may burn through the ribbon.
Darkness settings may also be changed by the driver or
software settings.
software settings.
PRINT SPEED
Press SELECT to make change.
Adjusting print speed: Press PLUS (+) to increase print
speed and MINUS (–) to decrease print speed. Speed is
measured in inches per second (ips). The default is 2 ips.
speed and MINUS (–) to decrease print speed. Speed is
measured in inches per second (ips). The default is 2 ips.
Press SELECT to accept the change.