Zebra Technologies Z4Mplus 用户手册

60

 

Z4Mplus and Z6Mplus User Guide

Configuration

You can leave the program mode at any time by pressing SETUP/EXIT. The SAVE 
CHANGES display appears. There are five choices, which are described below. 
Pressing PLUS (+) or MINUS (–) displays other choices and pressing SELECT selects 
the displayed choice.

• PERMANENT — Permanently saves the changes. Values are stored in the printer 

even when power is turned off.

• TEMPORARY — Saves the changes until you change them again or until power is 

turned off.

• CANCEL — Cancels all changes from the time you pressed 

SETUP/EXIT, except for darkness and tear-off settings (if they were changed).

• LOAD DEFAULTS — Loads factory defaults.
• LOAD LAST SAVE — Loads values from the last permanent save.

Press SETUP/EXIT again to save your choice.

Note • Once the password has been entered correctly, it does not have to be entered 
again unless you leave and re-enter the programming mode using SETUP/EXIT.

Note • You can disable the password protection feature to no longer prompt you for 
a password by setting the password to 

ØØØØ

 via the 

^KPØ

 

ZPL/ZPL II command. To re-enable the password-protection feature, send the ZPL/
ZPL II command 

^KPx

, where 

x

 can be any number that is one to four digits in 

length, except 

Ø

.