Motorola Single Board Computer 用户手册

1-1

This chapter provides information on hardware preparation and 
installation for the MVME5100 Series of Single Board Computers.

Unless otherwise specified, the designation “MVME5100” refers 
to all models of the MVME5100-series Single Board Computers.

The following subsections include information helpful in preparing your 
equipment. It includes and overview of the MVME5100, any equipment 
needed to complete the installation, and unpacking instructions.

The MVME5100 interfaces to a VMEbus system via its P1 and P2 
connectors and contains two IEEE 1386.1 PCI Mezzanine Card (PMC) 
Slots. The PMC Slots are 64-bit and support both front and rear I/O.

Additionally, the MVME5100 is user configurable by setting on-board 
jumpers.  Two I/O modes are possible: PMC mode or SBC mode (also 
called 761 or IPMC mode). The SBC mode uses the IPMC712 I/O PMC 
and the MVME712M Transiton Module, or the IPMC761 I/O PMC and 
the MVME761 Transition Module. The SBC mode is backwards 
compatible with the MVME761 transition card and the P2 adapter card 
(excluding PMC I/O routing) used on the MVME2600/2700 product. This 
mode is accomplished by configuring the on-board jumpers and by 
attaching an IPMC761 PMC in PMC slot 1. Secondary Ethernet is 
configured to the rear.

PMC mode is backwards compatible with the MVME2300/MVME2400 
and is accomplished by simply configuring the on-board jumpers.