Motorola Single Board Computer 用户手册
![Motorola](https://files.manualsbrain.com/attachments/83de88ba2280e7232128e8931d7cbd2a38dcc654/common/fit/150/50/0293f422c4d32e7e0f777d5e11bc33c83ea5627f71ddf155374c02a23d9a/brand_logo.png)
1-4
Computer Group Literature Center Web Site
Hardware Preparation and Installation
1
It is important to note that some options are not software-programmable.
These specific options are controlled through manual installation or
removal of jumpers, and in some cases, the addition of other interface
modules on the MVME5100.
These specific options are controlled through manual installation or
removal of jumpers, and in some cases, the addition of other interface
modules on the MVME5100.
The following table lists the manually
configured jumpers on the MVME5100, and their default settings.
If you are resetting the board jumpers from their default settings, it is
important to verify that all settings are reset properly. For example,
the SBC mode requires setting jumpers 4, 10 and 17 for rear Ethernet
functions, but it also requires resetting jumpers J6 and J20.
Neglecting to reset J6 and J20 could damage or destroy subsequent
PMCs or PrPMCs installed on the base board at power-up.
important to verify that all settings are reset properly. For example,
the SBC mode requires setting jumpers 4, 10 and 17 for rear Ethernet
functions, but it also requires resetting jumpers J6 and J20.
Neglecting to reset J6 and J20 could damage or destroy subsequent
PMCs or PrPMCs installed on the base board at power-up.
Table 1-1. Manually Configured Headers/Jumpers
Jumper
Description
Setting
Default
J1
RISCWatch Header
None (Factory Use Only)
N/A
J2
PAL Programming Header
None (Lab Use Only)
N/A
J4
Ethernet Port 2 Selection
(see also J10/J17)
For P2 Ethernet Port 2:
Pins 1,2; 3,4; 5,6; 7,8 (set when in SBC
mode, also called 761 mode)
mode, also called 761 mode)
No
Jumper
Installed
(front
panel)
Jumper
Installed
(front
panel)
For Front Panel Ethernet Port 2:
No Jumpers Installed
J6, J20
Operation Mode
(Set Both Jumpers)
(Set Both Jumpers)
Pins 1, 2 for PMC Mode
PMC
Mode
Mode
Pins 2, 3 for SBC Mode*
J7
Flash Memory Selection
Pins 1, 2 for Soldered Bank A
Socketed
Bank B
Bank B
Pins 2, 3 for Socketed Bank B
J10, J17
Ethernet Port 2 Selection
(see also J4)
(see also J4)
For Front Panel Ethernet Port 2:
Pins 1, 3 and 2,4 on Both Jumpers
Front
Panel
Ethernet
Panel
Ethernet
Port 2
For P2 Ethernet Port 2:
Pins 3, 5 and 4, 6 on Both Jumpers (set
for SBC mode)
for SBC mode)