Brady 260M 用户手册
Power On Self Test
A Power ON Self Test (POST) is performed each time the printer is
turned ON. This test checks for proper initialization of various
electronic circuits and establishes starting parameters as those stored
in the printer’s memory. During this test sequence, the front panel
lights will turn ON and OFF to ensure proper operation. At the end
of this self test, only the POWER light will remain lit. If other lights
are also lit, refer to the Troubleshooting Section.
turned ON. This test checks for proper initialization of various
electronic circuits and establishes starting parameters as those stored
in the printer’s memory. During this test sequence, the front panel
lights will turn ON and OFF to ensure proper operation. At the end
of this self test, only the POWER light will remain lit. If other lights
are also lit, refer to the Troubleshooting Section.
Printer Self Tests
Introduction
These self tests produce sample labels and provide specific
information that helps determine the operating conditions for the
printer.
information that helps determine the operating conditions for the
printer.
Each self test is enabled by holding in a specific Front Panel key
or combination of keys while turning the Power Switch ON.
Keep the key depressed until the Front Panel Lights turn ON.
or combination of keys while turning the Power Switch ON.
Keep the key depressed until the Front Panel Lights turn ON.
When the Power On Self Test is completed, the selected self test
automatically starts.
automatically starts.
Notes: When performing self tests, all data interface cables
connected to the rear of the printer must be removed.
When canceling a self test before its actual completion,
always turn the printer Power OFF and then back ON to
reset the printer.
always turn the printer Power OFF and then back ON to
reset the printer.
When performing these self tests in the Peel-Off Mode, the
operator must remove the labels as they become available.
operator must remove the labels as they become available.
Unless specifically stated, all tests print in Tear-Off mode
in Tear-Off printers and in Peel-Off Mode for Peel and
Rewind printers.
in Tear-Off printers and in Peel-Off Mode for Peel and
Rewind printers.
If your media is not wide enough, the test labels will only
print out to the edge of the label. If your media is too short,
the test label will continue printing on the next label.
print out to the edge of the label. If your media is too short,
the test label will continue printing on the next label.
Operation
M-Series User s Guide
3-6