AEG 1000 用户手册
46
Battery discharge
Batteries are currently
discharging, e.g. due
to a power outage.
discharging, e.g. due
to a power outage.
Battery disconnected
Battery system not available
because currently not
connected.
because currently not
connected.
7.3.2 Event
log
Up to 127 events are stored in the internal non-volatile event
memory in the UPS. The last event that occurred is the first on
the list, followed by other previous events. Similar to the
messages and alarms, each event is shown in its own window.
An event is indicated along with the date and time, followed by a
description in plain text. The numerical code facilitates error
analysis and other procedures in dealing with the event that has
occurred (also see Chapter 9.1.1 on pg. 59ff.). In the lower right-
hand corner of the display, you will find the total number of
events already stored as well as your position when scrolling
through the window. “1/…” indicates the most recent, last stored
event (= starting position when accessed).
If there are no events stored or if the event memory has been
deleted (also see Chapter 7.3.6 on pg. 49ff.), the following
message will appear: “No events in the event log”.
memory in the UPS. The last event that occurred is the first on
the list, followed by other previous events. Similar to the
messages and alarms, each event is shown in its own window.
An event is indicated along with the date and time, followed by a
description in plain text. The numerical code facilitates error
analysis and other procedures in dealing with the event that has
occurred (also see Chapter 9.1.1 on pg. 59ff.). In the lower right-
hand corner of the display, you will find the total number of
events already stored as well as your position when scrolling
through the window. “1/…” indicates the most recent, last stored
event (= starting position when accessed).
If there are no events stored or if the event memory has been
deleted (also see Chapter 7.3.6 on pg. 49ff.), the following
message will appear: “No events in the event log”.
Accessing the event log
Access the event log by pressing “ESC” to go to the main menu
and then pressing “▲” or “▼” to go to the “Event log” menu item
(line appears highlighted) and then press “ENTER” (basis /
starting point is the UPS status display).
Access the event log by pressing “ESC” to go to the main menu
and then pressing “▲” or “▼” to go to the “Event log” menu item
(line appears highlighted) and then press “ENTER” (basis /
starting point is the UPS status display).
Return to the UPS status display by pressing “ESC” again (or
automatically after 5 minutes if no other keys are pressed).
automatically after 5 minutes if no other keys are pressed).