AEG 1000 用户手册
47
EN
7.3.3 Measurements
Select this menu item to find the following measurements in this
order:
order:
Power Usage Efficiency
[%]
Output power
(active and apparent power)
(active and apparent power)
[W] & [VA]
Output power
(current and power factor)
(current and power factor)
[A]
Output
(voltage and frequency)
(voltage and frequency)
[V] & [Hz]
Input
(voltage and frequency)
(voltage and frequency)
[V] & [Hz]
Battery
(voltage and charge state)
(voltage and charge state)
[V] & [%]
DC bus
(intermediate circuit voltage)
(intermediate circuit voltage)
[V]
External battery modules
Total kWh consumption
[kWh]
i
If you want to see any particular measurement on
the screen permanently, you can “freeze” the screen
in the Measurements menu. To do so, press “▲”
and “▼” for approx. 3 seconds at the same time until
a small key appears in the upper right-hand corner
of the display. Press the two buttons again at the
same time for approx. 3 seconds to cancel this
setting.
the screen permanently, you can “freeze” the screen
in the Measurements menu. To do so, press “▲”
and “▼” for approx. 3 seconds at the same time until
a small key appears in the upper right-hand corner
of the display. Press the two buttons again at the
same time for approx. 3 seconds to cancel this
setting.
7.3.4 Control
During normal mode, you can active this menu item to access
the following sub-menu items: “Go to bypass mode”, “Battery
test”, “Reset error state” and “Load segments”.
the following sub-menu items: “Go to bypass mode”, “Battery
test”, “Reset error state” and “Load segments”.
i
Depending on the operating mode, only those sub-
menu items that are available will appear.
menu items that are available will appear.