Juniper Networks 200 用户手册

Chapter 3 Configuring the Device

22

User’s Guide

Switches

11. Cable together the switches labeled “Switch 3” and “Switch 4.”
12. Cable together the switches labeled “Layer 3 switch 1” and “Layer 3 switch 2.”
13. Cable the switches labeled “Layer 3 switch 1” and “Layer 3 switch 2” to routers.

14. Turn the power switches for all devices ON.

For more advanced HA configurations, see the NetScreen Concepts & Examples ScreenOS 
Reference Guide.

P

ERFORMING

 I

NITIAL

 C

ONNECTION

 

AND

 C

ONFIGURATION

To establish the first console session with the NetScreen-200 Series device, use a vt100 
terminal emulator program through the provided RJ-45/DB9 serial port connector.

Establishing a Terminal Emulator Connection

To establish an initial console session:

1.

Plug the DB9 end of the supplied RJ-45/DB-9 serial cable into the serial port of 
your computer. (Be sure that the DB-9 is seated properly by screwing in the 
thumbscrews.)

2.

Plug the RJ-45 end of the cable into the Console port of the NetScreen-200 Series 
device. (Be sure that the RJ-45 clip snaps into the port and is seated properly.)

3.

Launch a Command Line Interface (CLI) session between your computer and 
the NetScreen-200 device using a standard serial terminal emulation program 
such as Hilgraeve Hyperterminal (provided with your Windows operating 
system). The settings should be as follows:

• Baud Rate to 9600

• Parity to No

• Data Bits to 8

• Stop Bit to 1

• Flow Control to none

4.

Press the ENTER key to see the login prompt.

5.

At the login prompt, type netscreen.