Raritan Engineering KX2-864 用户手册

 

Chapter 12: Command Line Interface (CLI) 

 

The Interface command is used to configure the Dominion KX II network 
interface. The syntax of the interface command is: 

interface [ipauto <none|dhcp>] [ip <ipaddress>] [mask 
<subnetmask>] [gw <ipaddress>] [mode <mode>] 

Set/Get ethernet parameters 

ipauto <none|dhcp> IP auto configuration (none/dhcp)

ip <ipaddress> IP Address 

mask <subnetmask> Subnet Mask  

gw <ipaddress> Gateway IP Address 

mode <mode> Set Ehternet Mode 
(auto/10hdx/10fdx/100hdx/100fdx/1000fdx)

 

Interface Command Example 

The following command enables the interface number 1, sets the IP 
address, mask, and gateway addresses, and sets the mode to auto 
detect. 

Admin > Config > Network > interface ipauto none ip 
192.16.151.12 mask 255.255.255.0 gw 192.168.51.12 mode 
auto

 

 

The name command is used to configure the network name. The syntax 
of the name is: 

name [devicename <devicename>] [hostname <hostname>]

Device name configuration 

devicename  <devicename>   Device  Name 

hostname   <hostname>     Preferred  host  name  (DHCP 
only)

 

Name Command Example 

The following command sets the network name: 

Admin > Config > Network > name devicename My-KSX2