Fujitsu eLux NG S26361-F2600-L134 用户手册

 

 

 

 

 

 

Build # 27

  

185

 

 

 

General 
Problem: 

You can change settings in the tabs Setup or Configuration, but your changes are 
overwritten when the device is restarted. 

Solution: 

Your Thin Client is managed. Remove it from or deactivate it in the Scout Enterprise 
software. 

Ch. 3.4, “Screen” 
Problem: 

eLux screen settings are incompatible with the monitor.  

Solution: 

If you are no longer able to view the Screen tab, either attach a compatible monitor, 
perform a Recovery Installation, or change the settings remotely using the Scout 
Enterprise management software. Alternatively, you can start the terminal using Safe 
Boot. Safe Boot allows you start the terminal in a mode which does not damage 
hardware. You can then change eLux NG settings. 

1.  Switch off the Thin Client immediately. 
2.  Restart the Thin Client. 
3.  During the boot procedure, the BIOS information is displayed. When the screen 

goes blank, press the TAB key. 

4.  The eLux NG logo will be displayed, and then the prompt “Please enter admin 

password”. Enter the terminal password (“elux” by default). 

•  If an invalid password is entered three times, the terminal restarts. 

5.  At the prompt “factory reset (y/n)?” type n. You can now access eLux NG and 

make changes to settings in a mode that is safe for the monitor. Previous settings 
information is not lost. 

6.  Restart the Thin Client to exit Safe Boot mode. 

Ch. 3.4, “Screen” 
Problem: 

Font server error (in the dialog box Setup > Screen > New). 

Solution: ”Check 

the Font server:Port entry. 

•  The format is incorrect (font server:port), for example, the colon has not been 

entered, or the port number is missing or not a number. 

•  The font server name or address is incorrect. 
•  The font server cannot be reached. 

 
Check the Font path entry. 

•  The path does not exist. 
•  There is no file named fonts.dir in, for instance, the following directory: 

/

smb/share/dir or /nfs/host/dir 

 

Ch. 3.6, “Firmware” 
Problem: 

You are using an HTTP server. After starting the firmware update, the update stops and 
you receive one of the following errors: 

 

Error 401: Unauthorized