3com WX1200 用户手册

C

HAPTER

 19: RF D

ETECTION

 C

OMMANDS

Disables or reenables active RF detection scanning on a WX switch. When 
active scanning is enabled, the MAP radios managed by the switch look 
for rogue devices by sending probe any requests (probe requests with a 
null SSID name), to solicit probe responses from other access points. 

Syntax —

 set rfdetect active-scan {enable | disable}

„

 — Enables active RF detection scanning.

„

 — Disables active RF detection scanning.

Defaults — Active scanning is enabled by default.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — You can enter this command on any WX switch in the Mobility 
Domain. The command takes effect only on that switch. 

Examples — The following command disables active scanning on a WX 
switch:

WX1200# set rfdetect active-scan disable
success:  off-channel scanning is disabled.

Adds an entry to the attack list. The attack list specifies the MAC 
addresses of devices that MSS should issue countermeasures against 
whenever the devices are detected on the network. The attack list can 
contain the MAC addresses of APs and clients.

Syntax — 

set rfdetect attack-list mac-addr

„

— MAC address you want to attack.

Defaults — The attack list is empty by default.

Access — Enabled.

History —Introduced in MSS Version 4.0.

Usage — The attack list applies only to the WX switch on which the list is 
configured. WX switches do not share attack lists.