Sony DVS-9000 用户手册

   Chapter 3 

T

ransitions

C:\WINNT\Profiles\Administrator\Desktop\WORK_08_21\370467401
DVS9000WW\01GB05C03-WW.fm

194

Executing a Transition

DVS-9000/9000SF

3-704-674-01 (1)

If the transition rate is set to 100 frames, and the fader lever has moved 
through 1/4 of the transition, then the remaining 3/4 of the transition is 
carried out in 100 frames.

If the fader lever is in an intermediate position when a transition is completed 
as an auto transition, then the lever position no longer agrees with the transition 
state. This is termed a non-sync state.
In a non-sync state, two lit LEDs indicate the position from which a normal 
transition can be carried out. This is either at one end position or both end 
positions of the fader lever travel.
Moving the fader lever toward the position of the lit LEDs does not carry out a 
transition, but when the fader lever reaches the end position the non-sync state 
is released, and it is now possible to carry out the next transition.

• If the fader lever is moved in the direction away from the lit LEDs, this 

carries out the next transition, over the remaining part of the fader lever 
travel.

• Even in a non-sync state, you can carry out an auto transition by pressing the 

[AUTO TRANS] button. During the auto transition, the indicators show the 
transition progress in the usual way, but when the transition completes, they 
once again indicate the non-sync state.

Manual transition completed as auto 
transition when moving the fader 
lever upward: Top two LEDs light.

Manual transition completed as 
auto transition when moving the 
fader lever downward: Bottom two 
LEDs light.

Once the fader lever is moved 
to this position, the non-sync 
state ends, and the next 
transition (direction shown by 
the arrow) is possible.