Sony DVS-9000 用户手册

   Chapter 3 

T

ransitions

C:\WINNT\Profiles\Administrator\Desktop\WORK_08_21\370467401
DVS9000WW\01GB05C03-WW.fm

196

Transition Preview

DVS-9000/9000SF

3-704-674-01 (1)

To carry out a transition preview, use the following procedure.

In the M/E or PGM/PST bank transition control block, press the [TRANS 
PVW] button.

The [TRANS PVW] button lights green, and the switcher is now in the 
transition preview mode. At this point, the preview output is the same as 
the program output before the [TRANS PVW] button was pressed.

Operate the fader lever, or press the [AUTO TRANS] button or [CUT] 
button.

On the preview monitor, you can check the effect of the transition.

There are three modes for a transition preview. To terminate a transition 
preview, carry out the operation which depends on the mode, and press the 
[TRANS PVW] button, turning it off.
Lock: Toggling the [TRANS PVW] button on and off switches between the 

transition preview mode and the normal mode.

Hold: The preview mode obtains only while the [TRANS PVW] button is held 

down.

One Time: Each time a transition ends, it reverts to the normal mode.

• During a transition, whether executed with the [AUTO TRANS] button or 

the fader lever, it is not possible to press the [TRANS PVW] button.

• In bus fixed mode (see page 33), transition previews are not available.