Motorola WS5100 用户手册

5-31

 

2. Select the 

 tab.

3. Refer to the following information within the Member tab:

4. Select a row, and click the 

 button to display additional details for this member. For more 

information, see 

.

5. Select a row and click the 

button to remove a member from the redundancy group. The 

redundancy group should be disabled to conduct an Add or Delete operation.

Displays the IP addresses of the redundancy group member. 

Displays the current status of this group member. This status could have the following 
values:

• Configured: The member is configured on the current wireless service module.

• Seen: Heartbeats can be exchanged between the current switch and this member.

• Invalid: Critical redundancy configuration parameter(s) of the peer (heartbeat time, 

discovery time, hold time, Redundancy ID, Redundancy Protocol version of this member) 
do not match this switch’s parameters.

• Not Seen: The member is no more seen by this switch. 

• Established: The member is fully established with this current module and licensing 

information already been exchanged between this switch and the member. 

• Unknown: No status information could be obtained.

Displays the time when this member was last seen by the switch.

Displays the number of access ports adopted by this member.

Displays the number of licenses installed on this member.

The Redundancy Mode could be Active or Standby depending on the mode configuration on 
the member. Refer to the Configuration screen to change the mode.