Cisco Systems 3750E 用户手册
38-21
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-02
Chapter 38 Configuring IP Unicast Routing
Configuring RIP
Default RIP Configuration
shows the default RIP configuration.
Configuring Basic RIP Parameters
To configure RIP, you enable RIP routing for a network and optionally configure other parameters.
Beginning in privileged EXEC mode, follow these steps to enable and configure RIP:
Table 38-4
Default RIP Configuration
Feature
Default Setting
Auto summary
Enabled.
Default-information originate
Disabled.
Default metric
Built-in; automatic metric translations.
IP RIP authentication key-chain No authentication.
Authentication mode: clear text.
IP RIP receive version
According to the version router configuration command.
IP RIP send version
According to the version router configuration command.
IP RIP triggered
According to the version router configuration command.
IP split horizon
Varies with media.
Neighbor
None defined.
Network
None specified.
Offset list
Disabled.
Output delay
0 milliseconds.
Timers basic
•
Update: 30 seconds.
•
Invalid: 180 seconds.
•
Hold-down: 180 seconds.
•
Flush: 240 seconds.
Validate-update-source
Enabled.
Version
Receives RIP Version 1 and 2 packets; sends Version 1 packets.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
ip routing
Enable IP routing. (Required only if IP routing is disabled.)
Step 3
router rip
Enable a RIP routing process, and enter router configuration mode.
Step 4
network network number
Associate a network with a RIP routing process. You can specify multiple
network commands. RIP routing updates are sent and received through
interfaces only on these networks.
network commands. RIP routing updates are sent and received through
interfaces only on these networks.