Porter-Cable PCB270TS 用户手册

–  31  – 

Since accessories, other than those offered by Porter-
Cable, have not been tested with this product, use of 
such accessories with this tool could be hazardous. 
To reduce the risk of injury, only Porter-Cable 
recommended accessories should be used with this 
product.

A complete line of accessories is available from your 
Porter-Cable Factory Service Center or a Porter-Cable 
Authorized Warranty Service Center. Please visit our 
Web Site www.portercable.com for a catalog or for the 
name of your nearest supplier.

ACCESSORIES AND ATTACHMENTS

Do not use any accessory unless you have completely 
read the Instruction Manual for that accesory.

To avoid the risk of personal injury:

•

   Do not use a dado with a diameter larger than 8 in. 

(203.2 mm). 

•

   Maximum dado width is 13/16 in. (20.6 mm). DO 

NOT USE WIDER COMBINATIONS.

•

   Do not use molding head set with this saw.

•

   Do not modify this power tool.

For assistance with your product, visit our website at www.portercable.com for a list of service centers, or call the  

Porter-Cable Customer Care Center at (888) 609-9779.

Blade does not raise or 
tilt freely.

1.  Sawdust and dirt in elevation/tilting  

mechanisms.

1.  Brush or blow out loose dust and dirt.

Blade does not come 
up to speed. Reset trips 

too easily.

1.  Extension cord too light or too long.

2.  Low house voltage.

1.  Replace with adequate size cord.

2.  Contact your electric company.

Machine vibrates 
excessively.

1.  Saw not mounted securely to workbench.

2.  Bench on uneven floor.
3.  Damaged saw blade.

1.  Tighten all mounting hardware.

2.  Reposition on flat level surface. 
3.  Replace blade.

Does not make accurate 
45° and 90° crosscuts.

1.   Miter gauge out of adjustment.

1.  Adjust miter gauge.