Husqvarna WS 440 HF 用户手册

English

 – 11

1

Slip in the blade guard guide between the stays on the 
blade guard.  Place the blade guard guide in the middle.  
Lock the plastic heel on the handle to the upper stay on 
the blade guard. 

2

Make sure that the pivot arm is positioned vertically.  Lift 
the blade guard over the blade and hang the guard in the 
blade guard holder on the saw. Exercise care so that the 
runners on the blade guard are positioned in the slots on 
the water block.

3

Lock the blade guard by pulling the handle out of the 
guard and then down towards the saw unit so that the 
latch locks the handle. 

4

To remove the guard, release the latch and pull the handle 
upwards and inwards to the guard. Lock the plastic heel 
on the upper stay. 

5

Connect the water hose from the out-coupling on the saw 
motor to the in-coupling on the blade flange hub.

Read through the manual supplied with the power unit before 
starting to use the machine. 

When the saw unit, the blade and the blade guard are 
mounted, the power cable (A) and the water cooling (B) 
should be connected to the power unit.

IMPORTANT! This machine is only intended for use  
together with a Husqvarna PP 440 HF. All other use is 
forbidden.