Husqvarna WS 440 HF 用户手册

English

 – 9

Fit the wall mounting as set out below:

1

Mark off the cutting line and mark off the expander bolts 
holes 165 mm (6.5") from the cutting line.

2

Drill 15 mm (5/8”) holes for the M12 (1/2”) expander bolts.

3

Hang the wall mountings loosely from the expander bolts, 
using M6S 12 x 70 (1/2”x2”) or similar.

4

Place the rail in the wall mountings and tighten the 
compression washers.

For vertical cuts, the rail must be mounted with the saw 
carriage lock handle upwards. This to facilitate fitting the 
saw unit. 

5

Check that the rail is properly aligned with the tracks on 
the wall mounts before tightening the screws. 

6

Adjust the distance between the cutting line and the wall 
mounting. The distance between the edge and the inner 
face of the saw cut should be 89 mm (3.5"). Tighten the 
expander bolts.

•

The saw carriage is mounted on the rail at delivery.  The 
carriage can be dismounted from the rail by removing the 
end stop on the rail and pulling the carriage away. 

1

Fit the saw body in the saw carriage by lifting the saw body 
into position. When the saw is lifted into position, the 
locking handle moves up into an intermediate position. In 
this position the saw remains in the saw carriage without 
it needing to be held. However, it is not sufficiently secured 
to begin cutting.

2

To secure the saw, lift the locking handle towards the saw 
until the handle locks.

IMPORTANT! Only use the connectors supplied when 
purchasing the saw as older connectors are not designed 
for the WS 400 series.