Delta 36-5000 用户手册

15

1.  To install throat plate, lower blade below tabletop, 

then carefully feed the throat plate, with plate end 

first, from the front of the table to the rear, keeping 

the blade centered within the slot on the throat 

plate. See Figure 11. The plate should rest within 

the cavity in the tabletop on top of 5 flat head 

screws.

2.  Ensure that the throat plate is flush with the top of 

the table. 

3.  If the throat is not flush with the tabletop, adjust 

the height of the throat plate using the five set 

screws (A) below the throat plate. 

NOTE: When installing riving knife, anti-kickback 

pawls and blade guard, blade must be at 90° setting 

and raised to the maximum height. See Raising and 

Lowering Blade, page 18.

1.  Your saw is shipped with the blade and riving knife 

installed and properly aligned. The riving knife 

comes installed in the low, non-through cutting 

position.  Prior to operating your saw, check 

to make sure the alignment of the blade to the 

miter slot and the riving knife to the blade was not 

affected by shipping.  To check alignment of the 

blade and riving knife, see page 28 in the Alignment 

section of this manual.

2.  The riving knife comes installed in the low, non-

through cutting position. To attach the anti-

kickback pawls and blade guard assemblies, the 

riving knife must be in the raised position as shown 

in Figure 12. To raise and lower the riving knife, see 

Riving Knife Height Settings on page 20.

1.  Refer to Figure 12 and locate the anti-kickback 

pawls mounting slot (A) in the middle of the top 

edge of the riving knife.

2.  Slide slot in the middle of the anti-kickback pawls 

assembly along the top of the riving knife until the 

stem (B) locates the center slot on the riving knife.

3.  Depress the stem on the anti-kickback pawls 

assembly (B) to allow the assembly to drop 

into the slot. Push down on the anti-kickback 

pawls assembly until it snaps into place and 

locks. Release stem. NOTE:  Pull  up  on  the  anti-

To remove the anti-kickback pawls, depress the stem 

(B) and pull the anti-kickback assembly off the riving 

knife.