Delta 36-5000 用户手册

16

1.  While holding the blade guard assembly (A) in a 

vertical position, hook the locating pin (B) at the 

back end of the blade guard assembly into the slot 

at the back edge of the riving knife.

2.  Rotate the blade guard assembly toward the front 

of the saw until the metal portion (C) of the blade 

guard assembly is parallel to the table as shown in 

Figure 13. 

3.  While holding down on the front of the metal 

portion of the guard (C) press the blade guard 

lock lever (D) down until it snaps into the locked 

position. Check to make sure the guard is locked 

onto the riving knife by pulling on the guard. If the 

guard is not locked, the blade guard lock lever will 

flip up to the unlocked position. 

1.  Lift the blade guard assembly lock lever (D) to the 

unlocked position. 

2.  Rotate the guard back and slide the pin (B) from the 

riving knife slot.

Attach the handle to the fence cam
The rip fence slides onto the rear fence rail so that the 

hook is under the rear rail and rides on the front guide 

tube. The fence locks in place by applying pressure in 

a downward motion on the rip fence handle. Rip fence 

alignment should be checked prior to using your saw. 

To check alignment of the rip fence, see alignment 

instructions on page 29. 

Insert miter gauge into each miter slot to make sure it 

slides freely. See Adjusting the Miter Stops section on 

page 28 for adjustment of miter gauge accuracy. 

The Delta #36-5000 series contractor table saw 

comes with on-board storage for the provided miter 

gauge, arbor wrench, push stick and fence. There 

is also on-board storage for spare saw blades (sold 

separately). The miter gauge, spare blade and arbor 

wrench storage areas are located on the right side 

panel of the machine and come pre-installed. 
On-board storage for the fence and the push stick is 

located on the left side of the saw.