Whirlpool GU3100XTVS 用户手册

NOTE: It is recommended that the drain hose be looped up 
and securely fastened to the underside of the counter.

1. Using 2 or more people, place the dishwasher on its back on a 

piece of cardboard.

2. Using a 

¹⁄₄" hex socket, nut driver or Phillips screwdriver, 

remove the 4 screws attaching the toekick panel and lower 
panel to the dishwasher. 

3. Remove both panels and set aside on a protected surface.
4. Apply thread seal tape to 90º elbow fitting and connect fitting 

to water inlet valve.

5. Tighten elbow until snug.

NOTE: Elbow should face to the rear of the dishwasher.

6. Remove terminal box cover.

■

Direct Wire—Install a U.L. listed/CSA certified clamp 
connector to the terminal box. If using conduit, use a U.L. 
listed/CSA certified conduit connector.

■

Power Supply Cord—Install a power supply cord kit that is 
U.L. listed and marked for use with dishwashers (Part 
Number 4317824).

7. Measure the shortest opening height between the underside 

of the countertop and the floor where the dishwasher will be 
installed. 

8. Extend leveling legs out from the dishwasher base, 

¹⁄₄" less 

than the shortest opening height.

A

A