Whirlpool GU3100XTVS 用户手册

1. Using 2 or more people, place the dishwasher upright in front 

of cabinet opening.

2. With one person holding the dishwasher to avoid tipping, 

open and close the dishwasher door a few times. If the door 
closes easily or falls open under its own weight, adjust the 
tension.

■

If the door closes too quickly, decrease the spring tension 
by pulling the spring adjustment pin out of its hole and 
reinsert it into the next hole toward the back of the 
dishwasher.

■

If the door falls open, increase the spring tension by 
pulling the spring adjustment pin out of its hole and 
reinserting it into the next hole toward the top of the 
dishwasher. 

NOTE: The spring adjustment pins should be in the same holes 
on both the left-hand and right-hand sides of the dishwasher.

1. Using 2 or more people, grasp the sides of the dishwasher at 

the edges of the door panel and move dishwasher close to the 
cabinet opening.
NOTE: Do not push on the front of the panel or on the console 
to avoid bending or denting them. 

2. If direct wired, check that the power supply wire is on the 

right-hand side at the front of the cabinet opening.
If using a power supply cord, insert the power supply cord 
through the hole cut in the cabinet wall.

3. Check that the water supply line is on the left-hand side of the 

cabinet opening.

4. Check that the drain hose is near the center and to the front of 

the cabinet opening.

5. Slowly move the dishwasher into place inside the cabinet 

opening with the front corners of the dishwasher door flush 
with the cabinet doors.

■

Do not kink or pinch the copper tubing, drain hose, power 
supply cord or the direct wire between the dishwasher and 
the cabinet.

■

Do not removed the insulation blanket from dishwasher to 
allow the dishwasher to fit easier into the cabinet opening. 
The insulation blanket reduces the sound level when the 
dishwasher is operating.

6. If needed, support the front of the dishwasher by raising, 

lowering or shimming the front legs.

7. Remove cardboard from beneath the dishwasher.

1. Align the front of the dishwasher door panel with the cabinet 

doors by adjusting the front legs using the 6" (15.24 cm) 
adjustable wrench. 

2. Check that the leveling legs are firmly against the floor.
3. Close and latch the dishwasher door.
4. Place a level against the front panel above the leg to check 

that the dishwasher is plumb. If needed, adjust the leveling leg 
or add shims until the dishwasher is plumb.
NOTE: Shims must be securely attached to the floor to avoid 
their movement during dishwasher operation.

5. Repeat for the other side of the dishwasher.
6. Place the level against the top front opening of the tub. Check 

that the dishwasher is level from side to side. If the 
dishwasher is not level, adjust the front legs up or down until 
the dishwasher is level.